[C38] Exhaust manifold exhaust flange on Universal 5424/M30.

[Duff, Russ (R.W.)]

It's always something; at least it couldn't have happened at a better time.
We finally got the boat launched yesterday, and while pulling into the slip,
the exhaust note changed and there was no water coming out of the exhaust.
It turns out the fitting where the exhaust hose clamps onto the exhaust
manifold snapped off. Luckily this is a separate part bolted on to the back
of the exhaust manifold; the exhaust flange. My question is, is this a
single cast part with a round opening/neck that the hose clamps onto, or is
it a cast threaded part with a round opening that a pipe is thread into
(1981 model C-38)? According to the Torresen website, it is a threaded
opening.  Unfortunately, because it was late in the day, I couldn't get a
good look at it, but the neck didn't seem to be as long as what is shown in
Torresen's picture. I am hoping that just the pipe snapped, and not the
flange. It sure would be nice not to have to spend $81.07, plus shipping,
and instead just go to the local hardware and buy a section of pipe. If it
is just the pipe that snapped, what kind of pipe should be used? If anyone
as any experience with this, please let me know.  Thanks. 

 

Sincerely,
Russ Duff
Catalina 38, Hull #112
"AVANTURA"
Lake Erie
Grosse Ile, Michigan
RDUFF AT VISTEON DOT COM

AVANTURA AT COMCAST DOT NET

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://catalina38.org/pipermail/listserve_catalina38.org/attachments/20080529/2769489f/attachment-0001.htm>