[C38] prop shaft

[Max Soto]

Hi David,
We already have the first drawing, but not the las two. They will make a
great addition to the site.
Do have anymore of these Catalina drawings????
Did you already sell Superstar???
Regards,

Max

2011/11/7 David Epstein <davidepstein at earthlink.net>

>  Bob,
>
> Attached are three drawings from Catalina, titled "Prop Schedule", "Shaft
> Length Schedule" and "Strut and Shaft Schedule".  I hope these help.
>
> David Epstein
> SuperStar #122
> Marina del Rey
>
>
>
> At 11:43 AM 11/7/2011, you wrote:
>
>      Gentlemen and ladies, if any of you have your prop shaft removed, for
> a cutlass bearing, coupler, pack less seal or any other reason, I would
> greatly appreciate if you would measure your prop shaft and send the info
> to the E-mail below.  Please tell me if your shaft is an original
> silicon/bronze shaft.  My shaft is 47 inches long. Kiwi props tells me that
> the recommended kiwi prop is 15.5 X 22 degrees and requires one half inch
> of hull clearance. I can not fit a prop of this size.  Kiwi tells me that 4
> cat 38 have this prop.  I wonder if my prop was shortened.  I use a 13 X 13
> chris craft prop that has a bushing in it so it will fit the taper on my
> shaft. This 13 inch prop has one inch of hull clearance.  Any info would be
> greatly appreciated .
>
> bob gouley
> Zephyr hull # 142
> St Joseph Island
> ontario canada
> r.gouley at sympatico.ca
> _______________________________________________
> Listserve mailing list
> Listserve at catalina38.org
>  http://catalina38.org/mailman/listinfo/listserve_catalina38.org
>
>
> _______________________________________________
> Listserve mailing list
> Listserve at catalina38.org
> http://catalina38.org/mailman/listinfo/listserve_catalina38.org
>
>


-- 
Max Soto
C38 #198 ESTANCIA
Puntarenas, Costa Rica
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://catalina38.org/pipermail/listserve_catalina38.org/attachments/20111109/e10238b0/attachment-0001.htm>