[C38] Spreader Problem / Sail Re Cut

[tdtron at earthlink.net]

I think we are saying the same thing but here is my description on setting
the spreader angles.

I adjust my spreaders so the shroud angles are the same above and below the
tip of the spreader. This makes any lateral force on the spreaders to be
directly toward the spreader base with no force bias to either lift or drop
the spreaders. 

I put small stainless hose clamps on the shrouds below the spreader tips to
help hold the spreaders at that equal angle.  With the hose clamps
installed, I can actually stand on the spreaders near the mast and the
spreaders still hold their angle.

Tom Troncalli



> [Original Message]
> From: RICHARD KILROY <dickkilroy at comcast.net>
> To: Catalina 38 Listserve <listserve at catalina38.org>
> Date: 5/15/2012 5:24:38 PM
> Subject: Re: [C38] Spreader Problem / Sail Re Cut
>
> Mark: Spreaders are supposed to be @ 90% to the shrouds. I have a similar
> problem on my 38.the lower spreaders want to point about at the waterline,
> uppers are about right. Have chosen to ignore this
>
> Dick
> ----- Original Message ----- 
> From: "Mark O'Dell" <mixedbusinesscontact at gmail.com>
> To: "Catalina 38 Listserve" <listserve at catalina38.org>
> Sent: Tuesday, May 15, 2012 12:11 PM
> Subject: [C38] Spreader Problem / Sail Re Cut
>
>
> > Hey C38ers...
> >
> > One for the whole group:
> >
> > My first row / lower spreaders are angled funny. They are both
> > pointing down to the deck enough to be noticeably odd-looking. When I
> > got the boat the port side spreader was angled down slightly, but the
> > starboard was fine, now they both seem to have settled at a downward
> > angle. Not horrible, but obviously not right.
> >
> > So.. how to I fix that? And, is there a standard angle at which they
> > should be set?
> >
> > One for the Maryland guys:
> >
> > I need a recommendation for a loft to repair and re cut my Genoa and a
> > jib. My long-time loft has basically gone out of business, and I am
> > looking for a new one. I have a radial cut North Sail 150% that needs
> > cleaning, repair and needs to be re cut (it's too big up top. can't
> > sheet it in enough to get close angle without it resting quite tightly
> > on the top spreader.)  I also have a 110% that needs a sacrificial
> > furler piece sewn on.
> >
> > I was spoiled with my old loft... his prices were unheard of. Now I'm
> > scared to shop around. Anybody out there?
> >
> > Thanx,
> > Mark O'
> > #230 Momentous
> > Baltimore, MD
> >
> > _______________________________________________
> > Listserve mailing list
> > Listserve at catalina38.org
> > http://catalina38.org/mailman/listinfo/listserve_catalina38.org
>
>
> _______________________________________________
> Listserve mailing list
> Listserve at catalina38.org
> http://catalina38.org/mailman/listinfo/listserve_catalina38.org