[C38] Innerstay deck fitting
Ray Torok
torok13731 at gmail.com
Tue Apr 12 22:28:34 EDT 2022
Hi Max,
I'm afraid that's as far as I got before we sold the boat. I did try to
use the spare jib halyard to pull up a small inner jib or staysail, but
could never get enough tension on it to make the sail work properly.
Ideally I think the attachment point should be just above the topping lift
attachment, but then you need running backstays to support the load on the
inner forestay.
Good luck, Ray
On Tue, Apr 12, 2022 at 6:34 PM Max soto <maxsoto at gmail.com> wrote:
> Thank a lot Ray! Nice setup. It seem you followed the Catalina
> instructions quite good! My windlass is installed right 8n the center, so
> might have to check if it fits like that. What are you using on your mast
> to attaché the innerstay? Where did you installed it?
>
> BTW, thanks for the Dux tip. Not familiar with it, so I’ll be che that
> out.
>
> Regards,
> Max Soto A.
> +506-8312-1367
> Alajuela, Costa Rica
>
> On Apr 11, 2022, at 10:20, Ray Torok <torok13731 at gmail.com> wrote:
>
>
> Hi Max,
>
> I did this by mounting back-to-back padeyes on the deck at the aft end of
> the chain locker, with a turnbuckle going down to a piece of 3/4 or 1 inch
> plywood glassed to the hull with epoxy resin. There are enough layers of
> fiberglass connecting the plywood to the hull and wrapped around it, so
> that even if the plywood wasn't there, the fiberglass could take the load.
> Where the turnbuckle goes through the bottom of the chain locker, I glued
> in a PVC pipe cap with a hole in the end, and sealed around the turnbuckle
> with butyl to allow some flexibility. See pics below.
>
> By the way, I spoke with a rigger who recommended using Dux, rather than
> Dyneema, to avoid the creep problems of Dyneema.
>
> I hope this helps,
> Ray
>
>
>
> On Fri, Apr 8, 2022 at 4:57 PM Max soto <maxsoto at gmail.com> wrote:
>
>> Hi everybody, do any of you have a permanent innerstay deck fitting
>> installed on the bow? (Not the adjustable one on a track that came with
>> the spinnaker package).
>> If so, could you please send some pics of it and what’s strengthening it
>> below the deck?
>> Planning to install a removable Dyneema innerstay for the storm jib..
>>
>> Regards,
>> Max Soto A.
>> C38 #198 Estancia
>> +506-8312-1367
>> Alajuela, Costa Rica
>> _______________________________________________
>> Listserve mailing list
>> Listserve at catalina38.org
>> http://catalina38.org/mailman/listinfo/listserve_catalina38.org
>>
> _______________________________________________
> Listserve mailing list
> Listserve at catalina38.org
> http://catalina38.org/mailman/listinfo/listserve_catalina38.org
>
> _______________________________________________
> Listserve mailing list
> Listserve at catalina38.org
> http://catalina38.org/mailman/listinfo/listserve_catalina38.org
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://catalina38.org/pipermail/listserve_catalina38.org/attachments/20220412/2c2123d1/attachment-0001.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Inner stay 5.JPG
Type: image/jpeg
Size: 101840 bytes
Desc: not available
URL: <http://catalina38.org/pipermail/listserve_catalina38.org/attachments/20220412/2c2123d1/attachment-0005.jpe>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Inner stay 1.JPG
Type: image/jpeg
Size: 124968 bytes
Desc: not available
URL: <http://catalina38.org/pipermail/listserve_catalina38.org/attachments/20220412/2c2123d1/attachment-0006.jpe>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Inner stay 2.JPG
Type: image/jpeg
Size: 159492 bytes
Desc: not available
URL: <http://catalina38.org/pipermail/listserve_catalina38.org/attachments/20220412/2c2123d1/attachment-0007.jpe>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Inner stay 6.JPG
Type: image/jpeg
Size: 66893 bytes
Desc: not available
URL: <http://catalina38.org/pipermail/listserve_catalina38.org/attachments/20220412/2c2123d1/attachment-0008.jpe>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Inner stay 4.JPG
Type: image/jpeg
Size: 127754 bytes
Desc: not available
URL: <http://catalina38.org/pipermail/listserve_catalina38.org/attachments/20220412/2c2123d1/attachment-0009.jpe>
More information about the Listserve
mailing list