[C38] Anchor chain

[Rich West]

Hi Charles,

I had 300 feet of 1/4 inch high-test galvanized chain on Legacy (no line).
It worked great but when it was time to replace the chain, I went to 200
feet of that same chain and 200 feet of line.  My reasoning being that most
of the time, the 200 feet of chain is enough.  When I need to anchor deep,
300 feet is usually not enough.  By making the change, I also save some
weight in the bow.

The one thing I don't like about my new system is that the wet line is in
the chain locker with the chain and I'm afraid it will promote rust.  I
think I'm going to make some stainless hangers so that the line can could up
around the periphery of the chain locker and not constantly contact the
chain.

Rich, Legacy, #360



-----Original Message-----
From: listserve-bounces at catalina38.org
[mailto:listserve-bounces at catalina38.org]On Behalf Of Charles Finn
Sent: Monday, May 15, 2006 9:19 AM
To: Catalina 38 Listserve
Subject: [C38] Anchor chain


It is time to deal with an upgrade to my anchor chain.  I have a Delta
35# fastset as my main anchor.  I am going to put new chain on as the
current length is too short.  My research is confusing to say the
least!  The "old" solution is galvanized, American chain...  But this
chain is not really that strong compared to what's available these
days.  For example, the 5/16 proof coil is good for about 1400# working
strength, but grade 5/16 grade 70 "binder chain" working load is over
4000#....   In addition, the grade 70 chain has a "chromate" covering,
which is clearly harder than galvanized...
So, here are my questions:

1.  What length of chain are you using?
2.  What size?
3.  What type?
4.  Has anybody tried the grade 70? Especially in freshwater?

Comments welcome!
Charles Finn
Mighty Quinn  #114

_______________________________________________
Listserve mailing list
Listserve at catalina38.org
http://catalina38.org/mailman/listinfo/listserve_catalina38.org