[C38] Fuel tank removal

[Rob Cornelsen]

I have an 83 and do not have any door on the front of
my quarter berth.  I removed the tank last year to
replace the raw water seacock.  I had to use a long
screwdriver and a lot of patience.

Rob

--- "Duff, Russ (R.W.)" <rduff at visteon.com> wrote:

> Interesting.  I haven't removed my tank, but I have
> an '81 and it has a
> cabinet door (just like all the others) already
> built into the forward part
> of the quarter berth panel.  Maybe this came with
> the later models.  It
> sounds like you don't have one. 
> 
> Sincerely,
> 
> Russ Duff
> 
> RDUFF at VISTEON.COM
> 
> Visteon Climate Control
> D64
> 45000 Helm Street
> Plymouth, MI  48170
> 
> Phone:734-582-2782
> 
> -----Original Message-----
> From: listserve-bounces at catalina38.org
> [mailto:listserve-bounces at catalina38.org] On Behalf
> Of Gus Woods
> Sent: Thursday, May 03, 2007 10:42 AM
> To: Listserve at catalina38.org
> Subject: [C38] Fuel tank removal
> 
> A couple of years ago there was a question posted
> about possible problems
> removing the fuel tank and the general answer was
> "It's too easy to warrant
> any advice!"
> 
> Either my tank is not where the others are or I'm
> not as smart as the rest
> of you because I can't see how I can get the screws
> out without cutting an
> access port in the forward panel under the quarter
> berth. Love & Luck was
> built in September of '79 (#46 I think) and the tank
> is under the quarter
> berth with the forward edge of it several inches
> past the edge of the access
> panel above it. There are two flanges welded to the
> back of the tank with
> three screws in each and I can feel a similar
> arrangement on the outer edge
> of the front of it but I will have a difficult time
> getting a screwdriver on
> any of those three and I cannot get my arm anywhere
> near where the fourth
> one is likely to be. If I can get those nine screws
> out I may be able to
> move it enough to tear out the remaining three.
> 
> I can put it back by creating a slot for the forward
> flanges to slide into
> but I am curious about whether that is where they
> are all located.
> 
> Any help you can offer is greatly appreciated.
> 
> 
> _______________________________________________
> Listserve mailing list
> Listserve at catalina38.org
>
http://catalina38.org/mailman/listinfo/listserve_catalina38.org
> 
> _______________________________________________
> Listserve mailing list
> Listserve at catalina38.org
>
http://catalina38.org/mailman/listinfo/listserve_catalina38.org
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com