[C38] Dinette Table off center

[Steve Smolinske]

I just noticed while putting down the table to make the double berth that the table does not fit into the settee cutouts nor does it abut the port settee.  Same is true if I rotate the table 180.  I am assuming that the table should fit squarely in between the fore and aft settee and that also there is no gap between the edge and the port settee.  It seems the easiest way to fix would be to remove the table from the post, lower the post all the way and then put the table in the correct place and attach the screws in the new locations from below.   Has anyone else run into this?

Steve 
Peregrine #312
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://catalina38.org/pipermail/listserve_catalina38.org/attachments/20080510/603f2265/attachment.htm>