[C38] shackles

[Phil Gay]

Our Whale bilge pump is located in the same position on Que Linda.

Phil Gay
C38 049 Que Linda
Everett, WA

-----Original Message-----
From: listserve-bounces at catalina38.org
[mailto:listserve-bounces at catalina38.org] On Behalf Of Les
Sent: Sunday, August 10, 2008 5:57 PM
To: Catalina 38 Listserve
Subject: Re: [C38] shackles

Your local stainless shop might be able to fabricate one for you.  You
can also check in your local hardware store in their bulk screws... Look
for some bins with blue on silver background labels.  That generally
marks the stainless stuff.  However stainless wouldn't make good spring
pins I think.  I suspect that the rolled pin was probably high carbon
steel, which would be pretty safe with stainless. But I could be wrong.

And since I don't know where you are located, I can only speculate what
stores might be near you, but a good surplus chandlery might have the
bit for you.

	Finally there is West Marine, or my favorite for the good stuff,
DownWind Marine, and the ultimate fixit shop, San Diego Marine
exchange.  

	You could also check out the local boatyards.

Now my question:

	I have a bilge pump which is a Kempax, about 6 1/2" diaphragm,
bulkhead
mounted bilge pump.  I don't know if this was Catalina Standard or not,
but I cannot find the parts or the replacement for this guy.  I would
like to keep the same pump because of the issues of patching the
mounting point on the forward edge of the cockpit stern seat.  It is on
the starboard side.  But it does need work and like yesterday.  So, what
do you all have or recommend, and is yours mounted in the same location?

Regards,
Les H
On Sun, 2008-08-10 at 17:08 -0700, Kenneth M. Sutto wrote:
>                      I have a situation that I hope someone can help
> me with. I replaced my main halyard, wire to rope, and the shackle
> hooking to the main sail is a Wichard "keypin with bar shackle" 5/16".
> I had to punch out the rolled pin holding the bar in the shackle to
> remove it. The rolled pin got pretty messed up  and I can't get it
> back in. I tried West Marine, Boater's World,every specialty parts and
> screw store  around. I called Wichard back east for help an no luck.
> One hardware store had a pin but it was aluminium I told him it won't
> match with stainless steel.
>                      Is there anyone that can tell me where I can get
> a 5/32 stainless steel rolled pin for this shackle? There is a picture
> of it in the West Marine catalog page 1183, also in the Defender
> catalog page 59. I don't really want to spend $40 for a new shackle
> and still have to pound out that roled pin to hook it up to my main
> haylard.
>  
>             Ken Sutto,
>                      Sundancer
> 
> 
> ______________________________________________________________________
> Get more from your digital life. Find out how.
> _______________________________________________
> Listserve mailing list
> Listserve at catalina38.org
> http://catalina38.org/mailman/listinfo/listserve_catalina38.org


_______________________________________________
Listserve mailing list
Listserve at catalina38.org
http://catalina38.org/mailman/listinfo/listserve_catalina38.org