[C38] seperating the coupling

[Larry Malmberg]

Bob, seems like the shipyard had to heat the bolts on our coupling and then
cut them off, I don't know if they used a torch to cut them but I do know
they had a heck of a time getting them off. 

 





Best regards,

Larry Malmberg-President

Larry Malmberg Investigations and Security, Inc.
505 North Arrowhead Avenue - Suite 510
San Bernardino, CA 92401-1200
909-383-8565, 800-655-4549 Facsimile 909-383-8566
PI 15211, PPO 112446

www.larrypi.com


All incoming and outgoing e mail is scanned with Norton AntiVirus.

Civil and Criminal, Surveillance, Internal Investigations, Personal and
Personnel Protection, GPS Tracking and Rental, Notary.

"The American Indians found out what happens when  you don't control
immigration"


"Life is not a journey to the grave with the intention of arriving safely in
a pretty and well preserved body, but rather to skid in broadside,
thoroughly used up, totally worn out, and loudly proclaiming; WOW-- What a
Ride!"

CONFIDENTIALITY NOTICE: This electronic message, including any attachments,
is for the sole use of the intended recipient(s) and may contain
confidential and privileged information. Any unauthorized review, copying,
use, disclosure or distribution of any parts of the contents of this
message/information is prohibited by federal law. Attempts to intercept this
message are in violation of Title 18 USC 2511(1) of the Electronic
Communications Privacy Act (ECPA), which subjects the interceptor to fines,
imprisonment and/or civil damages. If you are not the intended recipient,
please contact the sender by reply e-mail and destroy all copies of the
original message.

  _____  

From: listserve-bounces at catalina38.org
[mailto:listserve-bounces at catalina38.org] On Behalf Of bob gouley
Sent: Thursday, October 23, 2008 6:37 AM
To: listserve at catalina38.org
Subject: [C38] seperating the coupling

 

     I would like to sepaerate the coupling on my engine 5424 type, It is
held together by four bolts that I removed but the coupler will not come
apart. I am worried about damage if I force it apart.  The coupler has
llarge bolts with rubber washers on the circumference, I don`t think these
are to be removed?  Currently I am soaking the shaft set screws with
penetrating oil, as I can`t budge them, next is to seperate the coupler, any
advice would be greatly appreciated. bob

 

Zephyr # 142

ST Joes Island 

Ontario Canada

r.gouley at sympatico.ca 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://catalina38.org/pipermail/listserve_catalina38.org/attachments/20081023/379296c0/attachment-0001.htm>