[C38] Cutless Bearing Replacement
S. Orton
ssorton at sbcglobal.net
Sun Feb 8 21:18:31 EST 2009
Jonathan, You definitely do not have to pull the shaft to replace the
cutlass bearing. You pull the prop, slip a sleeve over the shaft and press
the bearing forward until it is clear of the strut. You notice I said
press, not hammer! The first time I watched the yard remove the bearing
with a hammer and about 4 years later, I had to rebed the strut. After the
bearing is clear of the strut, use a grinder to split the bearing (carefully
so you don't nick the shaft) and remove the halves from the shaft. I made a
tool (a wheel puller) to press the old bearing out and press the new bearing
in which is shown in a pic attached. The sleeve is a section of EMT,
expanded at one end to match the ID of the strut. Two 3/8's threaded rods
were used as the jacking device and the end plates were fabricated from 3/4
aluminum plate, which you can machine with wood tools.
Also I was able to remove the shaft with out dropping the rudder. With
the cutlass removed and the rudder turned very slightly I was able to slide
the shaft by hand past the rudder.
Good luck, Steve O
----- Original Message -----
From: "Jonathan Bixby" <jonbix at cox.net>
To: <listserve at catalina38.org>
Sent: Sunday, February 08, 2009 2:58 PM
Subject: [C38] Cutless Bearing Replacement
>I saw the tech notes on replacing the cutless bearing submitted by Steve
> Kaminsky, owner of Nanny. Steve, or anyone that knows, can the bearing be
> replaced without removing the rudder? I assume that the prop shaft has to
> be removed in order to replace the bearing, will the prop shaft slide by
> the
> rudder?
>
> Best Regards,
> Jonathan Bixby
> OSPREY
> #200
> Portsmouth RI
> 401-683-4082
>
>
>
> _______________________________________________
> Listserve mailing list
> Listserve at catalina38.org
> http://catalina38.org/mailman/listinfo/listserve_catalina38.org
-------------- next part --------------
A non-text attachment was scrubbed...
Name: CIMG0017.JPG
Type: image/jpeg
Size: 592390 bytes
Desc: not available
URL: <http://catalina38.org/pipermail/listserve_catalina38.org/attachments/20090208/790c1fa6/attachment-0001.jpe>
More information about the Listserve
mailing list