[C38] Protruding bolts question
Steve Smolinske
SSmolinske at rainierrubber.com
Thu Nov 18 15:36:43 EST 2010
Not sure but would guess that jam nuts have less threads as compared to standard ones and a lowering sheer value. On recessing I would check with Catalina.
Steve Smolinske
On Nov 17, 2010, at 6:28 PM, "Dan Kueng" <feedback6 at blueline-studios.com> wrote:
> Hello Everyone,
>
> Is there a solution for doing away with the protruding bolt nuts on deck and
> those inside on the ceiling? The latter have a washer, nut and cap nut. Is
> this really the original design? Why not at least use a jam nut to limit
> the bolt length a little? Plus locking should even be better:
> http://www.epcserver.com/Structural/Analysis/connection/info_jamnut.asp
>
> Assuming that the deck is about an inch thick, would it be possible to make
> a recess withough compromising strength? Or is there any other design that
> does away with the protruing nuts?
>
> What material is the core? Were there any material variations?
>
> On a similar note, did anyone install recessed cabin lights? Like those:
> http://www.westmarine.com/webapp/wcs/stores/servlet/ProductDisplay?productI
> d=96870&catalogId=10001&langId=-1&storeId=11151&storeNum=10109&subdeptNum=10
> 571&classNum=10576
> I assume that they need around half an inch depth.
>
>
> Thanks,
>
> Dan Kueng
>
>
> <P1230927.jpg>
> <recess.png>
> _______________________________________________
> Listserve mailing list
> Listserve at catalina38.org
> http://catalina38.org/mailman/listinfo/listserve_catalina38.org
More information about the Listserve
mailing list