[C38] Hurth Transmission Oil Level

[Max Soto]

Yeah, is located about half inch from the bottom, and you're right,  when checking oil level, it shouldn't be screwed..
Regards, Max

Sent from my iPod

On Jun 22, 2012, at 20:02, Mark Lewis <mwlewis2025 at gmail.com> wrote:

> Max,
>  
> I thought it was near the top, but I don't remember.  It was easy to see the ring, either way, and there is only one.
> 
> On Wed, Jun 13, 2012 at 9:59 PM, Max Soto <maxsoto at gmail.com> wrote:
> Top, or bottom???
> 
> Sent from my iPod
> 
> On Jun 13, 2012, at 21:33, Mark Lewis <mwlewis2025 at gmail.com> wrote:
> 
>> Mine is a ring near the top of the stick, and the manual says to not screw it in when taking a reading.
>> 
>> On Fri, Jun 8, 2012 at 4:48 PM, Rob Cornelsen <robcornelsen at yahoo.com> wrote:
>> Can anyone explain how to read the dip stick on the ZF Hurth reduction gear - There is a ring around the bottom and a small hole drilled about three inches above it near the threaded cap.
>> 
>> Thanks
>> 
>> Rob
>> 
>> _______________________________________________
>> Listserve mailing list
>> Listserve at catalina38.org
>> http://catalina38.org/mailman/listinfo/listserve_catalina38.org
>> 
>> _______________________________________________
>> Listserve mailing list
>> Listserve at catalina38.org
>> http://catalina38.org/mailman/listinfo/listserve_catalina38.org
> 
> _______________________________________________
> Listserve mailing list
> Listserve at catalina38.org
> http://catalina38.org/mailman/listinfo/listserve_catalina38.org
> 
> 
> _______________________________________________
> Listserve mailing list
> Listserve at catalina38.org
> http://catalina38.org/mailman/listinfo/listserve_catalina38.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://catalina38.org/pipermail/listserve_catalina38.org/attachments/20120624/345e1434/attachment-0001.htm>