[C38] Spreaders.

[Steve Smolinske]

Big rubber mallet, you can move them under load if its small, if it’s a big adjustment loosen them


From: Listserve [mailto:listserve-bounces at catalina38.org] On Behalf Of fleet2001 at aol.com
Sent: Thursday, May 11, 2017 9:37 AM
To: listserve at catalina38.org
Subject: Re: [C38] Spreaders.

According to the catalina 38 one design racing rules, the uppers are 32" and the
lowers are 40".  But how do I do it? Maybe loosen the shrouds, move the spreaders to the proper angle and have someone below tighten the shrouds while I hold it at the proper angle?

-----Original Message-----
From: Steve Smolinske <SSmolinske at rainierrubber.com<mailto:SSmolinske at rainierrubber.com>>
To: Catalina 38 Listserve <listserve at catalina38.org<mailto:listserve at catalina38.org>>
Sent: Thu, May 11, 2017 12:15 pm
Subject: Re: [C38] Spreaders.
Measure the distance from the tip of the spreader to the edge of the mast,  Not sure what it is supposed to be but I think it is in a previous thread from years ago.

From: Listserve [mailto:listserve-bounces at catalina38.org<mailto:listserve-bounces at catalina38.org?>] On Behalf Of fleet2001 at aol.com<mailto:fleet2001 at aol.com>
Sent: Thursday, May 11, 2017 9:11 AM
To: Listserve at catalina38.org<mailto:Listserve at catalina38.org>
Subject: [C38] Spreaders.

Can someone explain how to properly adjust the spreader angles?  I know that the uppers are 7 degrees and the lowers are 1 degree.

Thank you guys,

Rich Grassia "MERRICONEAG"
_______________________________________________
Listserve mailing list
Listserve at catalina38.org<mailto:Listserve at catalina38.org>
http://catalina38.org/mailman/listinfo/listserve_catalina38.org<https://linkprotect.cudasvc.com/url?a=http://catalina38.org/mailman/listinfo/listserve_catalina38.org&c=E,1,qlhjEVGwtPbGuWSfq7JSCAhCNFipUGxTt8Xmwm4C6yPgXTlTgbjB54bjGnoU_ENWMMeArQe1sPpF_x3V9quiL1RwDN-7cZ2ILzh_uWbqQf1nmwad46iaVp6yDQ,,&typo=1>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://catalina38.org/pipermail/listserve_catalina38.org/attachments/20170511/134be5b6/attachment-0001.htm>