[C38] Photos of Port cockpit locker mods.

[Duff, Russ (R.W.)]

If I recall, you continued the cut up the sidewall of the locker?
 
Sincerely, 
Russ Duff 
Catalina 38, Hull #112
"AVANTURA"
Lake Erie
Grosse Ile, Michigan
RDUFF AT VISTEON DOT COM 

-----Original Message-----
From: Listserve-bounces at catalina38.org
[mailto:Listserve-bounces at catalina38.org] On Behalf Of Tom T.
Sent: Tuesday, February 07, 2006 7:17 PM
To: Catalina 38 Listserve
Subject: Re: [C38] Photos of Port cockpit locker mods.


 
Hi Russ and gang,
 
This is an old sketch of the cutout I made when I cut out my sail locker
floor.  I made reinforcements to go between the angle aluminum to pads
bonded to the hull to give strength to the floor.
 
I don't have a photo but you really can't go wrong as long as you don't try
to get too close to the outside edge against the hull because the hull wraps
under the sail locker and if you don't leave at least a couple of inches of
lip you won't have enough room for the angle aluminum underneath that's
needed to make a lip for the cutout to sit on.
 
I countersunk my bolts holding the aluminum leaving a smooth flush surface
on the sail locker floor.
 
Replacing the rotten wood steering stop is not fun but at least it's
possible now without being 2' tall or removing the engine.  I went back with
wood but I used cell cured treated lumber instead of standard wood which as
we now know can and will rot.
 
I have my water pump and water filter mounted under the forward original
section of the locker floor which is about 7" wide from the cutout to the
forward bulkhead.  Putting them there is out of the way, easy to get to when
needed, and the pump is very quiet.
 
I am strongly of the opinion that the sail locker should have had a false
floor from the factory but at least this is a modification that we can
easily do.
 
Good luck.
 
Tom Troncalli
The Renata hull #95
St. Pete, Fla
 
 
 

----- Original Message ----- 
From: Duff, Russ  <mailto:rduff at visteon.com> (R.W.) 
To: C38-List  <mailto:Listserve at catalina38.org> (Listserve at catalina38.org)
Sent: 2/7/2006 2:24:15 PM 
Subject: [C38] Photos of Port cockpit locker mods.


This year I am finally going to remove my steering pedestal to replace the
rotten wood underneath it.  To make the job a little easier, I want to cut
out the floor of the port cockpit locker like discussed in this list a
couple of years ago ('03? Thanks to Tom T. and Don Strong).  If you have any
pictures of your modification, could you please send them to me, I would
greatly appreciate it.  Thanks.  

Sincerely, 
Russ Duff 
Catalina 38, Hull #112
"AVANTURA"
Lake Erie
Grosse Ile, Michigan
RDUFF AT VISTEON DOT COM 


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://catalina38.org/pipermail/listserve_catalina38.org/attachments/20060213/643fb71c/attachment-0001.htm>