[C38] Dinette Table off center

[Russ and Karleen Duff]

I think the boats originally came with a solid tube, not an adjustable one
(that is what we have).  The tube has to be removed and put aside to lay the
table in the correct position. It's kind of a PITA, but it is how it is
done.

 

Sincerely,

Russ Duff

Catalina 38, Hull # 112

"Avantura"

Lake Erie

Grosse Ile, MI

Avantura At Comcast DOT Net

 

  _____  

From: listserve-bounces at catalina38.org
[mailto:listserve-bounces at catalina38.org] On Behalf Of Steve Smolinske
Sent: Sunday, May 11, 2008 2:37 AM
To: Catalina 38 Listserve
Subject: [C38] Dinette Table off center

 

I just noticed while putting down the table to make the double berth that
the table does not fit into the settee cutouts nor does it abut the port
settee.  Same is true if I rotate the table 180.  I am assuming that the
table should fit squarely in between the fore and aft settee and that also
there is no gap between the edge and the port settee.  It seems the easiest
way to fix would be to remove the table from the post, lower the post all
the way and then put the table in the correct place and attach the screws in
the new locations from below.   Has anyone else run into this?

 

Steve 

Peregrine #312

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://catalina38.org/pipermail/listserve_catalina38.org/attachments/20080511/b2704a22/attachment.htm>