[C38] Our C38 doesn't have an overtemp alarm - or it doesn't work

Tue Jun 7 10:41:38 EDT 2011

We had an overheat situation 2 years ago. I'm happy to say that the engine
was not damaged - but we did not hear any alarm go off when the coolant
boiled over. I haven't read all of your "overheat" messages. What do you
know about malfunctioning warning alarms? 

Marci J. Brown
Check's In The Mail

-----Original Message-----
From: Chuck Finn [mailto:charles at finn.ws] 
Sent: Monday, June 06, 2011 8:26 AM
To: Catalina 38 Listserve
Subject: Re: [C38] Overheat False Alarm

David,
Unfortunately, I don't think you have gotten rid of your bubble.   The 
flow you observe with the cap off is kind of working as your pump is
circulating water, but it is more of an agitation rather than real flow.
Both Tom and Larry give you perhaps the two answers that routinely work.
Look to the forward, port side, bottom of your engine for the drain fitting.
You should notice if you trace it back that this location leads back to the
heat exchanger and your hot water heater (that is where this bubble
resides).  When you fill from the bottom, you fill the system in the
opposite direction of the water pump flow and this forces the bubble out and
up.  Remember your thermostat has only a small "flow hole" and it can take
time  (I usually take the thermostat out while doing this).
I can't tell you how much time and angst I went through to learn this!  
The damn bubble can move around so that sometimes it is distributed enough
to allow some flow, which makes you think some magic has happened and your
temp looks great.  And the next time it is concentrated and allows no flow!
And I can tell you without qualification that the bubble is a very close
cousin to that guy Murphy which means things go wrong at the worst time!

Any time you are working on the cooling side of your engine (pump impeller,
heat exchanger, coolant change, etc.), you should refill through the lower
fitting.  Adding antifreeze like Tom describes along with the expansion
modification is also a must as running just water in our engines should only
be done in emergencies.
One alternative I now use is I bought one of those inexpensive pumps that
fit on the end of a drill.  This allows me to pump my antifreeze in through
the bottom of the engine and I no longer have to drain down the system to
add it.

I hope this doesn't come across as complicated because it really is not.
The trick is installing a hose fitting to your drain valve.

What I think is most frustrating is that the Westerbeke/Universal folks must
know all about this problem, but do not comment on it!  Old time marine
engine mechanics know all about it, but most of the ones we run into at
shipyards are young...

Regards,
Chuck Finn
Mighty Quinn #114
Still not in the water because of flooding Great Lakes

On 6/5/2011 3:46 PM, david at dlrfilms.com wrote:
> This might be the solution right here!
>
> I have a coolant recovery tank, but I don't see how the pressure cap 
> would allow coolant to flow to it unless it was subject to high 
> pressure; the seal is spring loaded and takes quite a bit of force to
move.
>
> Furthermore, ran the engine with the coolant level down/cap off and it 
> ran just fine for 30 minute. I could see the coolant circulating
vigorously.
>
> But when I put the cap on I the temp rose and we were back to square one.
> As this was happening I was wondering whether or not caps were univeral.
>
> Will take mine to an autopart store and compare to a two-way.
>
> I love sailing. I hate motors.
>
>
>> Correction:
>>
>> I failed to mention replacing the pressure cap if anyone does install 
>> the coolant recovery tank as I described in my last post.  You will 
>> have to replace the original pressure cap with a modern 2-way cap 
>> made for recovery tanks.  Our original caps were one way only and 
>> will not allow the expansion tanks to operate.  Any automotive parts 
>> store should be able to match up your old cap with a new 2-way cap.
>>
>> Tom Troncalli
>>
>>
>> ----- Original Message -----
>> From: Richard West
>> To: Larrypi at roadrunner.com;Catalina 38 Listserve
>> Sent: 6/5/2011 11:47:18 AM
>> Subject: Re: [C38] Overheat False Alarm
>>
>>
>> Mine used to get air in the hoses to of from the water heater.  For 
>> some reason I don't really understand, this stopped the coolant from 
>> circulating in the engine.  It happened any time I had to disconnect 
>> those heater hoses for any reason.  The only solution I found was 
>> detaching one of the heater hoses and use a turkey baster to force 
>> coolant through the heater circuit.
>>
>>
>> RIch, Legacy, #360
>>
>>
>>
>>
>>
>> On Sun, Jun 5, 2011 at 7:45 AM, Larry 
>> Malmberg<Larrypi at roadrunner.com>
>> wrote:
>>
>> I believe there is a small plug near the water pump that you can 
>> remove, add coolant until it comes out, replace the plug, run the 
>> engine for a couple of moments, remove the plug again and air will 
>> come out, keep doing until you have no more air.  This is just from 
>> memory.
>>
>>
>>
>>
>>
>>
>> Best regards,
>>
>> Larry Malmberg
>>
>> 7231 Boulder Avenue Suite 507
>> Highland, CA 92346 PI 15211
>> Telephone  909-208-1847
>> FAX           909-991-7568
>>
>> E Mail  Larrypi at roadrunner.com
>>
>>
>>
>>
>> Life is short, Break the rules, Forgive quickly, Kiss slowly, Love 
>> truly, Laugh uncontrollably, And never regret anything that made you
smile..
>>
>> "The American Indians found out what happens when  you don't control 
>> immigration"
>>
>>
>> "Life is not a journey to the grave with the intention of arriving 
>> safely in a pretty and well preserved body, but rather to skid in 
>> broadside, thoroughly used up, totally worn out, and loudly 
>> proclaiming; WOW-- What a Ride!"
>>
>> CONFIDENTIALITY NOTICE: This electronic message, including any 
>> attachments, is for the sole use of the intended recipient(s) and may 
>> contain confidential and privileged information. Any unauthorized 
>> review, copying, use, disclosure or distribution of any parts of the 
>> contents of this message/information is prohibited by federal law. 
>> Attempts to intercept this message are in violation of Title 18 USC 
>> 2511(1) of the Electronic Communications Privacy Act (ECPA), which 
>> subjects the interceptor to fines, imprisonment and/or civil damages. 
>> If you are not the intended recipient, please contact the sender by 
>> reply e-mail and destroy all copies of the original message.
>>
>>
>> -----Original Message-----
>> From: listserve-bounces at catalina38.org 
>> [mailto:listserve-bounces at catalina38.org] On Behalf Of 
>> david at dlrfilms.com
>> Sent: Sunday, June 05, 2011 7:17 AM
>> To: listserve at catalina38.org
>> Subject: [C38] Overheat False Alarm
>>
>>
>> My engine is back to doing that thing where the temp gauge climbs, 
>> the alarm goes off, but the engine itself is not even too hot to 
>> touch, and I can stick my finger in the coolant without getting 
>> scalded.
>>
>> This problem plagued our 2008 and 2009 Summer sailing, but wasn't too 
>> big a concern because we never ran the engine for more than about 
>> 5-10 minutes.
>>
>> Thought I had it licked before our passage to the Caribbean in Nov 
>> 2009, and indeed, ran the motor for hours on end with no such 
>> problem.
>>
>> But now it's back, and with the wind out of the SE, that means 
>> getting back into the harbor is a long enough run to get the overheat 
>> false alarm.
>>
>> IIRC, cracking the thermostat housing open would (usually) solve the 
>> problem.
>>
>> The other thing I notice is that coolent is not following through the 
>> overflow tube to the reserve tank. It's not blocked; it seems like 
>> there's a air bubble that's keeping the coolant from flowing.
>>
>> I remember something about running the engine, and then adding more 
>> coolant after it burps or some such. I have my manual and will 
>> re-read.
>>
>> Meanwhile, any helpful hints are much appreciated.
>>
>>
>> _______________________________________________
>> Listserve mailing list
>> Listserve at catalina38.org
>> http://catalina38.org/mailman/listinfo/listserve_catalina38.org
>>
>>
>> _______________________________________________
>> Listserve mailing list
>> Listserve at catalina38.org
>> http://catalina38.org/mailman/listinfo/listserve_catalina38.org______
>> _________________________________________
>> Listserve mailing list
>> Listserve at catalina38.org
>> http://catalina38.org/mailman/listinfo/listserve_catalina38.org
>>
>
>
> _______________________________________________
> Listserve mailing list
> Listserve at catalina38.org
> http://catalina38.org/mailman/listinfo/listserve_catalina38.org