[C38] Pedestal mounted chart plotter
Don Strong
drstrong at ucdavis.edu
Sat Aug 13 12:39:15 EDT 2011
Rich:
Rich: from Edson, as pictured. But I cannot find the item on their
website. Regards, Don
On 8/13/11 9:22 AM, les wrote:
> On Mon, 2011-08-08 at 20:29 -0700, Richard West wrote:
>> Does anyone have their radar screen or chart plotter mounted at their
>> Edson pedestal? If so, what did you use for the mount? Does it get
>> in the way of getting to or from the wheel? Does it block your view
>> forward at all? Photos would be much appreciated.
>>
>> Thanks,
>>
>>
>> Rich, Legacy, Los Angeles
> For JACE, we chose the Eagle chartplotter. It is reasonable in size,
> but small. I created a mount from a piece of Mahogeny I had on hand. I
> took a 1"x3"x8" piece. Drilled a 1" hole about 3/4" from one end, then
> cut a notch out, through the middle of the hole, and used the notch
> piect to bolt around the pedestal guard. I ran the cables up through
> the deck and into the pedestal guard, and out a hole about 1" below the
> location I had decided on for the "arm". The standard mount is mounted
> by a 1&3/4" screw through the center of the bottom, through two very
> large fender washers, through the "arm" and then a washer and nyloc nut.
> The arm will swivel on the pedestal guard and the chartplotter will
> swivel on the arm, so it is articulated enough to reverse it and hide
> from the wind in the dodger while watching the gps. The NMEA cable
> routes down through the guard to the interface to the autopilot. This
> lets the GPS give route and course information to the autopilot (a
> Wheelpilot). The setup works quite well, with the exception that the
> autopilot wants to go off course about 1 mile before being guided by the
> gps. I have been told by the autopilot company that this is due to its
> not being calibrated. But I have run the cal procedure many times to no
> effect.
>
> In any event, it will run a course, but goes past the way points quite a
> distance before correcting back to the desired course.
>
> The wheel pilot remote can be plugged into a distribution cable
> receptacle that I mounted in the port Lazerette. This permits me to run
> the remote into the cabin via the galley pass through, and also run the
> remote at the chart table where I had an older garmin mounted. The
> garmin has run its course, and needs to be replaced.
>
> Next time I'm at the boat I will take a picture.
>
> Sorry for the late response on this one, I am just cleaning out my inbox
> and came across this.
>
> Regards,
> Les H
>
>
> _______________________________________________
> Listserve mailing list
> Listserve at catalina38.org
> http://catalina38.org/mailman/listinfo/listserve_catalina38.org
v
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://catalina38.org/pipermail/listserve_catalina38.org/attachments/20110813/fa1d8ecc/attachment-0001.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: cbhihjgj.png
Type: image/png
Size: 184404 bytes
Desc: not available
URL: <http://catalina38.org/pipermail/listserve_catalina38.org/attachments/20110813/fa1d8ecc/attachment-0001.png>
More information about the Listserve
mailing list